Table of Contents
Advertisement
PCI Quad 422/485 Card
NOTE: These software settings must match the RS485 Multiplex Jumper
configuration, as described in the section "RS485 Multiplex Jumper Settings"
in Chapter 2, to ensure accurate and error free data transmission.
CTS Hold True, determines whether the CTS handshake signal is INPUT from
the external serial device or is permanently forced true on the card. The serial
ports own RTS OUTPUT handshake signals are always taken out to the serial
port connector.
Restore - when this button is clicked the settings in the current window will be
reset to the default values of:
Enable FIFO:
Extend FIFO:
Receive Buffer:
Transmit Buffer:
485 Mode:
Chapter 6 Windows 95 Software Configuration x 30
On (Checked)
Off (Unchecked)
rd
3
from left.
16
Full duplex.
Advertisement
Table of Contents
