Table of Contents
Advertisement
PCI Velocity RS232422/485
PCI VELOCITY RS232/422/485
SOFTWARE CONFIGURATION
Introduction.
This section contains the installation procedures of the PCI
VELOCITY RS232/422/485 card, with the DOS, Windows 3.x
Windows 95, Windows 98/Millennium, Windows NT and
Windows 2000 operating systems.
The setup procedures in this chapter assume that your PC has only
one serial port present.
DOS Installation.
The DOS installation procedure consists of two steps after the PCI
RS232/422/485 card is inserted:
1. Determining the resources that the card has claimed.
2. Informing the Serial Solutions DOS device driver of those
resources.
Determining PCI RS232/422/485 Resources.
Insert card into PC, as described in Chapter 2.
Run BBCARDS.EXE, from the supplied Serial Solutions
CDROM by typing the following:
D:\diskimg\ssutil\pci\BBCARDS
Where D:\ is the Letter of your CDROM drive
BBCARDS.EXE will return a string that looks similar to the
following (values contained in the string may differ in individual
PC's due to resource availability):
card 1 is on bus 0, device 16, function 0
Card ID=5, revision 2: Dual Velocity RS232/422/485
interrupt line 11 has been assigned
2 sets of 16550-compatible registers are at I/O address 0140
Chapter 4
Chapter 3 Page 18
Software Setup
Advertisement
Table of Contents
