Configuring Ports I Ndos; Configuring Port In Do.; Determining Pci Dual Rs232 Resources - Brainboxes CC-257 Hardware Manual

PCI DUAL RS232
Configuring Ports In DOS.
The DOS installation procedure consists of two steps after
the PCI Dual RS232 card is inserted:
1. Determining the resources that the PCI Dual RS232 has
claimed.
2. Informing the Serial Solutions DOS device driver of those
resources.

Determining PCI Dual RS232 Resources.

Insert card into PC, as described in Chapter 2.
Run BBCARDS.EXE, from the supplied DOS utility disk titled
"Serial Solutions Utility Disk" by typing the following:
% @4'-@&&'%6(7
Where A:\ is the drive containing the supplied disk.
BBCARDS.EXE will return a string that looks similar to
the following (values contained in the string may differ in
individual PC's due to resource availability):
PCI Dual RS232 users:
w‚ˆs††‰„ˆÂ€w‚sÂ!!
"‡sˆ‡ÂƒtÂ!&%% qƒ„iˆwp€s†suw‡ˆs†‡
PCI Velocity RS232 users:
w‚ˆs††‰„ˆÂ€w‚sÂ!!
"‡sˆ‡ÂƒtÂ!&'% qƒ„iˆwp€s†suw‡ˆs†‡
Note down IRQ and I/O which in this case:
The IRQ = 11
The I/O address = 0140
Software Configuration
EQÂirr†s‡‡Â !$
EQÂirr†s‡‡Â !$
Chapter 3 Page 33