Table of Contents
Advertisement
PCI Quad RS232
PCI QUAD SOFTWARE
Introduction.
This section describes the software installation procedure
allowing the PCI Quad RS232 to be configured within the
Windows 3.x, Windows 95/98 and Windows NT operating
systems.
The setup procedures in this chapter assume that your PC has only
COM1 present.
Configuring Ports In Windows 3.x
The Windows 3.x installation procedure consists of 2 steps after the PCI Quad
RS232 card is inserted:
1. Determining the resources that the PCI Quad RS232 has
claimed.
2. Informing Windows 3.x of those resources.
Determining PCI Quad RS232 Resources.
Insert card into PC, as described in Chapter 2.
If you are installing from floppy disk run BBCARDS.EXE,
from the supplied DOS driver disk titled "Serial Solutions
Utility Disk" by typing the following:
If you are installing from the Serial Solutions CDROM the path
will be
Where
BBCARDS.EXE will return a string that looks similar to
the following (values contained in the string may differ in
individual PC's due to resource availability):
CHAPTER 3
INSTALLATION
is the drive containing the supplied disk.
Software Installation
Chapter 3 Page 14
Advertisement
Table of Contents
Need help?
Do you have a question about the CC-265 and is the answer not in the manual?