PCI DUAL RS232
Configuring Ports In Windows 3.x
The Windows 3.x installation procedure consists of two
steps after the PCI Dual RS232 CARD is inserted:
1. Determining the resources that the PCI Dual RS232 Card has
claimed.
2. Informing Windows 3.x of those resources.
Determining PCI Dual RS232 Resources.
Insert the card into a PC, as described in Chapter 2.
Run BBCARDS.EXE, from the supplied DOS utility disk titled
"Serial Solutions Utility Disk" by typing the following:
%@4'-@&&'%6(7
Where A:\ is the drive containing the supplied disk.
BBCARDS.EXE will return a string that looks similar to
the following (values contained in the string may differ in
individual PC's due to resource availability):
PCI Dual RS232 users:
wsÂwsÂ!!
"ÂsÂtÂ!&%% qiwpsÂsuws
PCI Velocity RS232 users:
wsÂwsÂ!!
"ÂsÂtÂ!&'% qiwpsÂsuws
Note down IRQ and I/O address, which in this case are:
The IRQ = 11
The I/O address = 0140
Software Configuration
EQÂirrs !$
EQÂirrs !$
Chapter 3 Page 27