PCI Photon Twin 9
SOFTWARE INSTALLATION
Introduction.
This section describes the software installation procedure allowing
the PCI Photon Twin 9 to be configured within the Windows 3.x,
Windows 95/98 and Windows NT operating systems.
Configuring Ports In Windows 3.x
The Windows 3.x installation procedure consists of 3 steps:
1. Insert the PCI Photon Twin 9 Card into a free PCI slot and
power up the PC.
2.
Determine the resources that the PCI Photon Twin 9 has
claimed.
3. Inform Windows 3.x of those resources.
Determining PCI Photon Twin 9 Resources.
Insert the card into a PC, as described in Chapter 2, power up
the PC
From DOS Run BBCARDS.EXE, Found on the Serial
Solutions CDROM, by typing the following:
Where <drive>is the drive containing the supplied disk.
BBCARDS.EXE will display a message that looks similar
to the following ( the values displayed may differ due to resource
availability):
CHAPTER 3
Software Installation
Chapter 3 Page 11