Configuring Ports I N Microsoft Windows Nt 4.0; Software Installation; Chapter 3 Page 20 - Brainboxes CC-431 Hardware Manual

Brainboxes cc-431 pci cards: hardware guide
Table of Contents

Advertisement

Software Configuration
Configuring Ports In Microsoft Windows NT 4.0
Microsoft Windows NT Provides built in support for 255
standard serial ports. To setup your PCI 3 Port Serial card you
should follow these steps. Please note that to change any kind of
hardware configuration under Windows NT you must be logged in
as a user with Administrator level privileges, if you do not have
these please contact your system administrator.

Software Installation.

Insert the PCI 3port RS232 into your PC, as described in
chapter 2, and restart. Place the supplied floppy disk titled "Serial
Solutions for Windows NT" in a suitable drive and from the Start
Menu choose Run and enter a:\setup (where a: is the path to
the floppy drive with the installation disk).
InstallShield will then install the driver software automatically -
it will then copy the necessary files and start itself. This
automatically detects your new PCI serial card(s) and does not
require any further system restarting.

Chapter 3 Page 20

PCI 3 Port RS232

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the CC-431 and is the answer not in the manual?

This manual is also suitable for:

Cc-420Pci 3 port rs232Pci 3+1 port rs232

Table of Contents