ADTRAN TA 544 User Manual page 47

The following settings are used for FRF5.
L FR M
AN
L FR P
AN
T392 (5-30)
FRN P
N
ATM VPI
ATM VCI
D
CLPI M
D/C
H
M
M
DLCI M
© 2001, ADTRAN, Inc.
P Frame Relay maintenance or signaling protocol
AINT ROTOCOL
between local V.35 port and the attached DTE
port, support ANSI Annex A, CCITT Q933 An-
nex D, CISCO LMI or Static (no signaling).
T T392 for signaling protocol, typical value 15. No
OLL IMEOUT
meaning if Maint Protocol is Static.
C
Logical Frame Relay ports over ATM. Up to 4
ORT ONFIG
ports are supported with each port supporting up
to 4 DLCI mappings. Go to
or "I" will insert another entry, and typing "d" or
"D" will delete one entry.
AME
M
E AP
AP
EADER
P
AINT ROTOCOL
M
UX ODE
AP
L DLCI
AN
N DLCI
ET
A
CTIVE
TA 544 User Manual/61200704L1-1A
N
UM
To identify your port.
Specifies the virtual path over which this
logical port is running.
Specifies the virtual circuit over which this
logical port is running.
Frame Relay to ATM DE mapping; default
O , ATM 0) suggested.
value (F
RN NLY
ATM to Frame Relay CLPI map; default
value (F O ) suggested.
RN NLY
Set D/C field in the header to 0 or 1.
Header format; only 2 bytes supported now.
Maintenance or signaling protocol over this
logical Frame Relay port. Support Annex A,
Annex D, CISCO LMI or Static.
Many DLCIs or one DLCI mapping over this
port.
Actual DLCI mappings.
The DLCI configured over local V.35
Frame Relay port.
The DLCI configured over the WAN
side logical Frame Relay port.
Always active, not configurable.
Page 47 of 68
field. Typing "i"
TA 544 User Manual