Advantage Engineering Titan Instruction Manual page 43

Titan Central Chillers
Back Buttons to advance between Month, Day and Year.
C. Set Time.
To Process
Main Menu
50°F
Setpoints
Utilities
Network
Flow
Options
S e t p o i n t : 50°F
Machine
Circulating
Back Pick Go
1. Set the time by selecting the Set Time option from the Machine Menu. Using the
Up and Down Arrow keys to select the hour, minute and seconds. Use the Select
and Back Buttons to advance between Hour, Minute and Seconds.
D. Minimum Setpoint. This parameter sets the lowest permissible setpoint temperature.
The factory default is 48°F. The range is from 20°F - 80°F.
Machine
Set Date
Set Time
Min Setpoint
Hi Temp Shutdown
Units
Back Pick Go
1. For Minimum Setpoints below 48°F. A warning is displayed when a minimum
setpoint below 48°F is entered. The warning ensures the operator is aware the
an appropriate mixture of water/glycol is circulating to prevent freezing.
To Process
50°F
S e t p o i n t : 50°F
Circulating
2.
After a minimum setpoint below 48°F is selected, a caution display will appear
when reducing the operating setpoint below 48°F. The warning must be
acknowledged before the change is made by pressing the Select button.
Machine
Set Date
Set Time
Min Setpoint
Hi Temp Shutdown
Units
Back Pick Go
3. For Minimum Setpoints 48°F and above. From the Machine Menu, advance
to the Minimum Setpoint screen to enter the minimum setpoint. Confirm the
selection with the Select Button.
To Process Machine
50°F
Set Date
Set Time
Min Setpoint
Hi Temp Shutdown
S e t p o i n t : 50°F
Units
Circulating
Back Pick Go
Minimum Setpoint
46°F
Back Adjust OK
To Process
50°F
S e t p o i n t : 50°F
Outputs ■ • • •
Minimum Setpoint
48°F
Back Adjust OK
ADVANTAGE ENGINEERING, INC.
525 East Stop 18 Road Greenwood, Indiana 46142
317-887-0729 Fax: 317-881-1277
Service Department Fax: 317-885-8683
Email: service@AdvantageEngineering.com
Set Time
14 : 42 : 42
Back Adjust Minute
Warning
Operation at less than
48°F requires appropriate
levels of glycol.
Cancel
Con rm
Back Select OK
ATTENTION
Glycol required
for this setpoint
S e t p o i n t : 47°F
Outputs ■ • • •
To Process FLow
Change Setting
50°F
Enable
Minimum Setpoint
Offset
Success
Calibration
Acknowledge
Page: 43