Operator Controls - Advantage Engineering Titan Instruction Manual

Titan Central Chillers
8.
manually reset to restart operations. Once the pump is restarted, check for
excessive motor amps at the motor starter block and throttle back the pump's
discharge valve as required.
3.3

OPERATOR CONTROLS

A.
Depending on the unit's standard and option configuration, the
number of switches and buttons maybe different than shown
below. A typical configuration is shown here.
B. Operator Controls
1. MASTER STOP / STOP. This controls the overall
operation of the unit. In the On position, the unit can
operation. In the Off position, the unit will not operate
even if power is applied to the unit. A power indication is
provided.
2. EMERGENCY STOP. This mushroom type button will
instantly stop all unit operation.
3. PUMP CONTROL. This controls the operation of the
pump. Each pump will has it's own control. There is 3
operations in this single control:
a.
b.
b.
Emergency Stop
Pump Controls
If during operations the motor overload trips, the overloads will need to be
On / Off switch. Turn On to activate the pump
and Off to deactivate.
Running Light. When the pump is operating this
light will glow Amber.
Overload Trip Light. If the pump has tripped on
the overload relay, this light will glow red.
525 East Stop 18 Road Greenwood, Indiana 46142
ADVANTAGE ENGINEERING, INC.
317-887-0729 Fax: 317-881-1277
Service Department Fax: 317-885-8683
Email: service@AdvantageEngineering.com
Master Start / Stop
Emergency Stop
Pump Control
Master Start
Page: 31