Advertisement
There are five screens each having a separate save areas. Pressing
ESC will access the Main Screen; pressing NEXT will scroll
through the save areas. To change a timer value, follow the same
procedures previously outlined.
Notice there are four timers required for the Dual Tamp mode.
PROD DLY1 (Product Delay 1) is the time delay between the
product sensor sensing the leading edge of the product to when
the applicator applies the first label; APPL DLY1 (Applicator
Delay 1) is how long the applicator engages the product for the
first label prior to returning home. PROD DLY2 (Product
Delay 2) is the time delay after the applicator returns home until
the next label is applied and APPL DLY2 (Applicator Delay 2) is
how long the applicator engages the product (second label) prior
to returning home. Press ESC (Escape) will exit this mode.
If required, a Config Button is provided in the Dual Tamp
th
Settings of a LX600DT or displayed along with the 5
Save Area
in a LX600T. The Config button is used to perform firmware
upgrades to the PanelView Screen only as they become available
and to configure the screen for another application as required by
the factory or a trained distributor technician.
Note: This button is not a required operator accessed
button for labeler functional changes. All necessary labeler
timer changes are found in the Setup Modes. Disregard this
button and press the ESC button to return to the main
screen.
Advertisement
