Signode LITTLE DAVID LX600 Operator's Manual page 43

With a Dual Tamp Applicator, in the SET UP mode, the
operator must determine the mode of operation of the Swing
Arm first (Single Tamp or Dual Tamp) before changing any of
the induvial timers. The following screens are used to configure
between a Single Tamp mode (i.e. Corner Wrap, Side Apply or
Front Apply only applications) or, Dual Tamp mode (Front and
Side Apply) and then the follow-on Save Areas and Timers setup
menus. Press the desired mode and then the TIMING SET UP
Screen will display:
If the DUAL TAMP SETUP was selected the following screen
will be displayed to select the desired Save Area / Preset Timers
and adjust the Product Delay(s) and Applicator Delay(s):
Note: Save Areas and Product Delay timers are now
displayed. In this screen shot example, the operator has