Advertisement
Background Suppressed Sensor P/N: E7367-BS2
The tamp applicator uses a sensor to detect when the applicator
Adjusting the
has made contact with your product. It may be necessary to adjust
Applicator
the sensitivity or range of this sensor to apply the label to your
Stroke Length
desired specifications.
With the air off and the power on, extend the cylinder until the
applicator pad touches the surface to be labeled and then turn the
dial until the yellow indicator light has just turned on. When the
light is illuminated, the sensor has detected the labeled surface
and will begin to blow the label down and retract the cylinder. It
is important that the sensor does not detect too early as the
cylinder will retract before applying the label and if it detect too
late, it may stall or damage your product or cylinder.
Adjusting the
Depending on your label size, you may need to move the pad
Applicator
closer (short labels) or further (long labels) from the peal edge of
Pad Pitch
the labeler. The applicator pad has a pitch adjustment inside the
vacuum chamber, under the pad.
Advertisement
