Advertisement
and the display will give various machine status (i.e. MACHINE
READY, NO FAULTS, etc.)
The main screen will boot up in the Stop condition. The general operator
screen navigations will be from this main screen once the system is set up. If
you want to JOG a label out to the applicator pad, depress the JOG button
which will momentarily turn black, then return to the STOP. To run the
labeler, depress the START button (START button will toggle to black and
the STOP button will turn white).
Always go to the STOP button first prior to going to another function.
Once back to the main screen, depress the SET UP button to enter other
functions. The next screen will appear. In this instance the Straight Tamp
Program is shown for illustration.
Note: a Dual Tamp HMI Screen will have similar screen layouts
however it will display more timers to adjust depending on the
particular application. Regardless of the type applicator, the
process is very similar. Since this is a Straight Tamp Version, only
a Product Delay setting needs to be changed as the return of the
cylinder is controlled by a Touch and Go sensor on the Pad.
Note: The desired Preset
area must be selected. The
screen shot at the left shows
that Preset 1 is selected.
The following pages will
show how to make timer
changes. The process is
similar for either a Straight
Tamp or Dual Tamp
Applicator PLC program.
Advertisement
