Advertisement
To make small pitch adjustments between the peel blade and the
applicator pad edge, loosen the (6) screws (3 each side) on the
applicator pad mount arm and adjust accordingly. Re-tighten
screws. Typically, a 1/8" gap is a good starting point.
Adjusting the
Depending on your label size, you may need to move the pad
Applicator
closer (short labels) or further (long labels) from the dispensing
Pad in
edge of the printer. The applicator pad has a pitch adjustment
inside the vacuum chamber, under the pad. There is also a side to
Relation to
side adjustment; loosen the M6 hex head screws and adjust
the Peel
accordingly.
Blade
Advertisement
