Advertisement
B. Alternatively or additionally, you may want to turn the machine
vertically. This is done with the handle found behind the machine.
Note: If the machine is to be inverted (sometimes called bottom
labeling) the handle should be completely removed to move the
machine upside-down. This will expose a new hole that can be
used for the lock handle so that the position is maintained.
C. Vertical height is changed with the handle on the top of the
machine.
Step Four:
desired position, you will want to load the labels. Loosen the outer clamp with
the handle and remove it, then load you labels as shown and replace the outer
guide. Prior to locking the outer guide in place, leave a little clearance between
the outer guide and the roll of labels; Do Not press the outer guide tightly
against the label roll as it will stop the label roll from unwinding normally and
stall the label feed. (Note: Side Frame Plate and cylinder are removed to
show detail.)
Once the labeler has been rotated to the
Advertisement
