Siemens SINAMICS G120 Operating Instructions Manual page 71

4. Select the control type according to your converter variant and make the necessary settings
for fail-safe digital inputs and the forced checking procedure (test stop):
Note
The illustration above takes a SINAMICS G115D PROFINET variant as an example. On AS-i
and I/O control variants, only the control type "via terminals" is available.
* Not available when selecting the control type "via terminals"
SINAMICS G120 Smart Access
Operating Instructions, 12/2020, A5E43332487-004
No. Parameter
① P9650
② P9651
③ P9610 *
④ P60022 *
⑤ r9773.1
⑥ P9659
⑦ r9773.31
Description Function
SI F-DI changeover Tolerance time to change over the
discrepancy time fail-safe digital input for the basic
(processor 1) [ms] functions.
Factory setting: 500 ms
SI STO debounce time Debounce time of the fail-safe digital
(processor 1) [ms] input for the basic functions.
Factory setting: 1 ms
SI PROFIsafe address Sets the PROFIsafe address for proces-
(processor 1) sor 1.
PROFIsafe telegram Sets the telegram number for PROFIs-
selection afe.
CO/BO: SI status (pro- Signals for the higher-level control
cessor 1 + processor system.
2)
Bit 1: STO is active in the drive
SI forced checking Monitoring time for the forced
procedure timer [h] dormant error detection.
Factory setting: 8 h
CO/BO: SI status (pro- Signals for the higher-level control
cessor 1 + processor system.
2)
Bit 31: Test stop is required for STO
Standard Web pages
5.4 Quick setup
69