Siemens SINAMICS G120 Operating Instructions Manual page 29

Frequency channel
Default channel: channel 11.
Total channels: 11. Each channel stands for a transmitting frequency. The frequency
difference between two adjacent channels is 5 MHz. You can select a desired channel with
the slider. Sliding right increases the transmitting frequency.
Signal strength
Default signal strength: 0 (strong)
The wireless network signal transmission distance may vary with environmental conditions.
When selecting the desired signal strength, consider both the acceptable signal transmission
distance and the corresponding wireless network security. You can select a desired strength
with the slider.
Resetting Wi-Fi configuration
When the SINAMICS G120 Smart Access is in power-on state, holding down the reset button
for more than three seconds resets the Wi-Fi configuration of the SINAMICS G120 Smart
Access to factory defaults.
Description
Wi-Fi name
Wi-Fi password
Wi-Fi frequency channel
Communication protocol
Note
Before pressing the reset button to reset the Wi-Fi configuration, make sure that the Wi-Fi
communication LED on the SINAMICS G120 Smart Access lights up solid green/solid yellow or
flashes green. The Wi-Fi configuration is reset successfully when the status of the Wi-Fi
communication LED flashes yellow. After resetting Wi-Fi configuration, restart SINAMICS
G120 Smart Access.
SINAMICS G120 Smart Access
Operating Instructions, 12/2020, A5E43332487-004
Factory defaults
G120 smart access_xxxxxx
12345678
11
http enabled
Standard Web pages
5.2 Optional settings page
27