Baofeng BF-H6 Series User Manual page 32

Keep pressed the [SK1] key for 3 seconds to start the alarm tone.
The following three options can be selected:
• On site:
the speaker emits an alarm tone but the radio doesn't transmit;
•Send sound: the speaker emits an alarm tone and the radio transmits it;
• Send code: the speaker emits an alarm tone and the radio transmits it followed by ANI-ID code.
(30) Scan of frequencies with CTCSS (Scan CTCSS) - Menu No. 29
The function allows scanning the frequencies with CTCSS tone enabled.
NOTES: The function cannot be activated when the radio is set in Channel mode. The Scan will start only when the
receiving band will detect a signal.
(31) Scan of frequencies with DCS (Scan DCS) - Menu No. 30
This function allows scanning the frequencies with DCS code enabled.
NOTES: The function cannot be activated when the radio is set in Channel mode. The Scan will start only when the
receiving band will detect a signal.
(32) Squelch tail elimination (TAIL) - Menu No. 31
This function is used eliminate squelch tail noise between POFUNG handhelds that are communicating directly (no
repeater). Reception of a 55 Hz or 134.4 Hz tone burst mutes the audio long enough to prevent hearing any squelch tail
noise.
(33) Squelch tail elimination of repeater (RP-STE) - Menu No. 32
This function is used when the radio operates through a repeater; when the PTT is released, the repeater will emit the end
transmission tone to confirm it is working.
Available settings:
OFF 1,2,3,4,5,....10 to set the delay time.
Note: Please disable this function in normal using, lest affect your normal conversation.
(34) Delay the squelch tail of repeater (RPT-RL) - Menu No.33
29