Baofeng BF-H6 Series User Manual page 28

(9) Keypad beep (Beep Prompt) - MENU No. 8
When this function is enabled, every time a button is pressed, you will hear a beep tone.
(10) Time-Out-Timer (Tx over time) - MENU No.9
The TOT function is used to prevent a too long transmission and limits the tx time: TOT temporarily stops the transmission
if the radio has been used beyond the max pre-set time (for example 15s, 30s, 45s, etc).
Note: If this option is set to OFF, press and hold the PTT key to keep transmission.
(11) Receiving DCS (Rx DCS) - MENU No.10
DCS codes are similar to access codes and can be added to channels, so as to create a sort of personal channel. They
enable the radio to communicate with the users that are tuned on the same channel and have set the same DCS code.
You can choose amongst:
• OFF:
OFF
• D023N-D754N (Normal DCS), D023I-D754I (Inverse DCS)
Note: In H6 there are 208 groups of normal and inverse DCS codes. This function cannot be amended in channel mode.
(12) Receiving CTCSS (Rx CTCSS) - MENU No.11
As DCS codes, the CTCSS codes can be added to the channels for creating new private channels.
Note: there are 50 groups of CTCSS tones. In channel mode the CTCSS tones cannot be changed.
(13) Transmitting DCS (Tx DCS) - MENU No.12
In this Menu you activate DCS codes in tx mode. You can choose between normal R-DCS (D023N-D754N) and inverted
R-DCS (D023I-D754I)
Note: the groups of DCS codes are 208. DCS codes cannot be changed in channel mode.
(14) Transmitting CTCSS (Tx CTCSS) - MENU No.13
In this Menu you can set a CTCSS tone in tx mode.
You can choose: OFF or CTCSS (67.0 to 254.1 Hz)
25