Table of Contents
Advertisement
Maintenance Mode
2 Display/Sound setting
■ Select [Setting] - [Display/Sound setting]
(1) Information Pop-up
• Select the display enable of Information Pop-up.
• The following items can be indicated in the Information Pop-up.
1. Refrigerant system and address of the Indoor unit which performs [On/Off], [RC all prohibited], [Operation
Mode shift] and [Setting temperature shift] depending on the external input signal.
2. Refrigerant system of the Outdoor unit which performs [Capacity control] and [Lower noise] depending
on external input signal.
3. H-LINK No. which performs [Emergency stop] depending on external input signal. (Only 00 for this unit)
4. External Output No. during Signal Output.
Example of Information Pop-up display
(2) Display Size
• Select the size of the screen.
(3) Modification of Time on the Monitor screen
• Select the modification time of the monitor.
When there is a connection other than 1 computer for 1 unit, set at 1 minute or more.
(4) Alarm sound
• When the alarm is generated, select the number of times it will be sounded.
(5) Each Control mode has its own color.
• Select each color when the unit is in operation.
(6) Indicate each Group (A to H) starting a new line.
• Select where to start a new line for the unit in each Group.
NOTE: After setting the item, if [Done] is selected, the setting will be reflected.
To reflect the setting of the display size, it is necessary to re-start the management application.
20
Management Mode
Control Mode
< This item is not required but set if necessary. >
Monitoring Mode
P5416904
Advertisement
Table of Contents
