Table of Contents
Advertisement
Maintenance Mode
7 RC group register
￭ Click on [Settings] then [RC Group register].
(1) RC Group register
1. Select the unit.
• When multiple units are controlled by one RC, select the multiple units.
2. Click on [Edit]
3. Select the RC group No.
4. Click on [OK].
• When registering multiple RC Groups, repeat steps 1 to 4.
5. Click on [Done].
NOTE:
To cancel the RC Group registration, click on [Cancel] after selecting the unit and then click on [Done].
②
④
NOTE:
● Always perform an RC group register for Indoor units connected.
● When the Register content of the RC Group and the actual RC Group do not match, because the
control is impossible, perform wiring properly.
● An indoor unit without a local zone controller is counted as one remote-control group.
● When registering an RC Group, the External Input cannot be correctly operated. Perform all the input
settings in an OFF state.
P5416904
Management Mode
< This is required. >
Control Mode
①
③
⑤
27
Advertisement
Table of Contents
