Hard Disk Led Connector (Hd_Led); Reset Switch (Reset); Speaker Connector (Speaker); Power Led Connector(Pwe Led) - QDI Advance 12 Series Manual

Hard Disk LED Connector (HD_LED)

The connector connects to the case's IDE indicator LED indicating the activity status of IDE
hard disk. The connector has an orientation. If one way doesn't work, try the other way.

Reset Switch (RESET)

The connector connects to the case's reset switch. Press the switch once, the system
resets.

Speaker Connector (SPEAKER)

The connector can be connected to the speaker on the case.
Power LED Connector (PWE LED)
When the system is in S0( full-on ) status, the LED is on. When the system is in S1( power
on suspend ) status, the LED is blink. When the system is in S5( soft-off ) status, the LED
is off. The connector has an orientation.
ACPI LED Connector (ACPI LED)(Reserved)
The ACPI LED is a double-color light with three pins. Pin1and Pin2 drive different color lights.
If Pin1 drives the orange light , then, Pin2 drives the green light, the following status will
come out. When the system is in S0 status, the LED is green on. When the system is in S1
status, the LED is green blink. When the system is in S5 status, the LED is off.

Hardware Green Connector (SLEEP SW)

Push once the switch connected to this header, the system enters suspend mode.
Chapter 2
HD_LED
Manual for Advance 12 series
HDD LED(+)
HDD LED(-)
ORANGE(-) VCC
GREEN(-) GND
LED+
NC
POWER SPKDATA
GND RESET
GND
EMPTY
EMPTY
EMPTY
LED+
SLEEP
GND
LED-
LED-
LED+
LED- GND
LED- KEYLOCK