Infrared Header (Irda); Fan Connector (Cpufan, Chsfan); Wake-Up On Lan (Wol) - QDI P6I440BX Manual

Installation Instruction

Infrared Header (IrDA)

This connector supports wireless transmitting and receiving. If using this function, set
"Serial Port 2 Mode" to IrDA or ASKIR then configure the settings in the "INTEGRATED
PERIPHERALS" section of the BIOS.

Fan Connector (CPUFAN, CHSFAN)

These two fans are controllable. They will be automatically turned off after the system
enters suspend mode. You also can choose not to turn the CPUFAN off by setting "CPUFAN
Off In Suspend" as Disabled in the "POWER MANAGEMENT SETUP" section of the BIOS.

Wake-Up On LAN (WOL)

Through the Wake-Up On LAN function, a wake event occurring from the network can
wake up the system. If this function is to be used, please be sure an ATX 2.01 power
supply of which 5VSB line is capable of delivering 720mA, and a LAN adapter which
supports this function are used. Then connect this header to the relevant connector on the
LAN adapter, set "Wake Up On LAN" as Enabled in the "POWER MANAGEMENT SETUP"
section of the BIOS. Save & exit, then boot the operating system once to make sure this
function takes effect.
22
NC
VCC
1
Manual for P6I440BX/BV
GND VCC
IRRX IRTX
CPUFAN
FAN GND(Controllable)
+12V
Tachometer Signal
Tachometer Signal
FAN GND
+12V
CHSFAN
+5V standby
GND
Signal for waking up (active high)