Table of Contents
Advertisement
Mounting Instructions
R
emove the four screws in the front cover and lift the cover. Remove the
black caps located on the three mounting holes. Mount the enclosure to the
wall using three screws. Be sure the electrical knockouts are at the bottom
of the enclosure in order to prevent water from entering the controller. Insert
the screws into the mounting holes and tighten. Fasten the black caps
onto the mounting holes.
Connections
T
o connect the controller, refer to the wiring diagram enclosed with this
user's manual.
Set the voltage switch to the appropri-
ate line voltage.
Route the cables through the electri-
cal knockouts provided at the bottom
of the enclosure. Do not make addi-
tional holes in the enclosure, particu-
larly on the side of the enclosure
when using a computer communica-
tion module.
It may be necessary to install a trans-
former on the heating stage in order to
supply the correct voltage to the
heater.
10
TC4-2N6F.rev.07
Voltage switch
Inside of the enclosure
Advertisement
Table of Contents
