Table of Contents
Advertisement
Minimum Speed Curve (cont'd)
To Specify the Points of the Minimum Speed Curve
Set selection knob to MIN.SPEED. The current stage 1 single
minimum speed appears flashing on the display.
Press push-button. The word OFF appears on the display, indi-
cating the minimum speed curve is deactivated.
Repeat the following steps for each of the six points:
Press push-button once again. A day number, preceded by the
letter "d", appears flashing on the display.
For the first point of the curve, use adjustment knob to adjust
the day number to the desired value. For all other points of the
curve, the day number can not be adjusted.
Press push-button once again. The current minimum speed for
this day number appears flashing on the display.
Turn adjustment knob to adjust the minimum speed to the de-
sired value.
NOTES:
(1) All six points of the curve must be specified. If you do not
need six different points, repeat your last minimum speed
for each unnecessary point of the curve.
(2) To reduce the risk of errors:
it is not permitted to specify decreasing minimum speeds;
the minimum speed variation can not exceed 10% per day.
When the six points of the minimum speed curve have been specified,
activate the minimum speed curve as described below (the minimum
speed curve can be activated only if the temperature curve is acti-
vated).
TC4-2N6F.rev.07
31
Advertisement
Table of Contents
