Installation Procedure; Equipment List; Mounting Instructions; Connections - Airstream TC5-ITA User Manual

INSTALLATION PROCEDURE

Equipment List

Integrating an air inlet control system into your ventilation system requires
the following equipment:
• A Comlink-2 communication module added to your controller
• A TC5-ITA controller for each air inlet panel (up to 100 in all)
• An alarm system (optional)
• A DC power supply (optional)
• A power unit.

Mounting Instructions

Open the latch and lift the cover. Remove the black caps located on each
of the four mounting holes. Mount the enclosure on the wall using four
screws. Be sure the electrical knockouts are at the bottom of the enclo-
sure in order to prevent water from entering the controller. Insert the screws
in the mounting holes and tighten. Fasten the four black caps provided
with the controller onto the four mounting holes. The enclosure must be
mounted in a location that will allow the cover to be completely opened
right up against the wall.

Connections

To connect the equipment, refer to the wiring diagrams enclosed with this
user's manual. Also refer to the DC power supply wiring diagram when
using a DC type motor.
• Use the electrical knockouts provided at the bottom of the enclo-
sure. Do not make additional holes in the enclosure.
• Set the voltage switch to the appropriate line voltage.
TC5-ITA rev.02
7