Choosing The Handset Volume (For Volume Amplify); Setting Volume Amplify - Brother MFC-795CW User Manual

Choosing the Handset
Volume (for Volume Amplify)
Before you begin to use the machine, you
must decide if you need to set the handset
volume to Volume Amplify: On for a user
who is hearing-impaired. The amplify volume
level complies with FCC standards.
Volume Amplify: Off
This default setting is appropriate if none of
the users are hearing-impaired. During a
conversation, users can press
on the LCD to adjust the volume to Low or
High. When the handset is replaced, the
handset volume will remain until you change
it again.
Volume Amplify: On -Temporary
This setting is appropriate if some of the
users are hearing-impaired. During a
conversation, users can press
on the LCD to adjust the volume to Low, High
or Amplify. When the handset is replaced,
the handset volume returns to the default
setting of Low.
Volume Amplify: On -Permanent
Choose Volume Amplify: On -Permanent
if all of the users are hearing-impaired. During
a conversation, users can press
on the LCD to adjust the volume to Low,
High or Amplify. When the handset is
replaced, the handset volume returns to the
default setting of Amplify.
Note
When you press
control panel to adjust the volume, the
LCD shows the setting you are choosing.
Each key press changes the volume to the
next setting.
3
or
or
or
or on the
WARNING
It is important that you DO NOT choose
Permanent unless ALL the users are
hearing-impaired. Otherwise, the default
setting of Amplify may damage the
hearing of some users.

Setting Volume Amplify

Please carefully read Choosing the Handset
Volume (for Volume Amplify) on page 27.
a
Press MENU.
b
Press a or b to display
General Setup.
c
Press General Setup.
d
Press a or b to display Volume.
e
Press Volume.
f
Press a or b to display
Volume Amplify.
g
Press Volume Amplify.
h
Do one of the following:
If none of the users are hearing-
impaired, press Off. Go to step j.
If some or all of the users are
hearing-impaired, press On.
i
Do one of the following:
If all the users are hearing-impaired,
press Permanent.
If only some of the users are hearing-
impaired, press Temporary.
j
Press Stop/Exit.
General setup
3
3
27