Handset Volume (Mfc-790Cw Only); Choosing The Handset Volume (For Volume Amplify) (Mfc-790Cw Only) - Brother MFC-790CW User Manual

Chapter 3
Handset Volume
(MFC 790CW only)
-
a
Press MENU.
b
Press a or b to display
General Setup.
c
Press General Setup.
d
Press a or b to display Volume.
e
Press Volume.
f
Press a or b to display Handset.
g
Press Handset.
h
Press Low or High.
i
Press Stop/Exit.
Note
You can adjust the handset volume any
time you are talking on the telephone.
There are two handset volume levels, Low
and High. The default setting is Low.
Press d or c to adjust the volume level.
The LCD shows the setting you are
choosing. The new setting will remain until
you change it again.
Choosing the Handset
Volume (For Volume Amplify)
(MFC-790CW only)
Before you begin to use the machine, you
must decide if you need to set the handset
volume to Volume Amplify: On for a user
who is hearing-impaired. The AMPLIFY
volume level complies with FCC standards.
28
Volume Amplify: Off
This default setting is appropriate if none of
3
the users are hearing-impaired. During a
conversation, users can press d or c on the
LCD to adjust the volume to Low or High.
When the handset is replaced, the handset
volume will remain until you change it again.
Volume Amplify: On -Temporary
This setting is appropriate if some of the
users are hearing-impaired. During a
conversation, users can press d or c on the
LCD to adjust the volume to Low, High or
Amplify. When the handset is replaced, the
handset volume returns to the default setting
of Low.
Volume Amplify: On -Permanent
Choose Volume Amplify: On -Permanent
if all of the users are hearing-impaired. During
a conversation, users can press d or c on the
LCD to adjust the volume to Low, High or
Amplify. When the handset is replaced, the
handset volume returns to the default setting
of Amplify.
Note
When you press d or c on the control
panel to adjust the volume, the LCD
shows the setting you are choosing. Each
key press changes the volume to the next
setting.
WARNING
It is important that you do NOT choose
3
Permanent unless ALL the users are
hearing-impaired. Otherwise, the default
setting of Amplify may damage the
hearing of some users.