Machines With Card Programmer - Primus R6 User Manual

E: EXTENDING THE WHOLE WASHING PROGRAM BY 10 MINUTES
By pressing this button, the prewash cycle will be extended by 1 minute, main wash cycle will be extended
by about 5 minute and the final spin cycle will be extended by about 2 minutes. This button can be pressed
at any time during the washing process.
F: LOWER WATER LEVEL AT EVERY FILLING UP
This function begins right after the button is pressed.
G: STOPPING THE PROGRAM CONTINUATION
This function begins right after its pressing. After its pressing the program stops in its current position, the
wash motor stops spinning, the programmer stops, the filling cycle will complete, the heating continues and
the machine is at rest.
For example, if it is pressed during washing, the soaking of the linen continues along with heating until it is
pressed again. After that the program continues.
H: EXTRA SHORT WASHING PROGRAM
An extra short washing process made up of 7.5 min. of washing and 5.5 min. of spinning is achieved by
pressing this button.
After pressing this button, the program will independently operate the liquid soap pump during set up time
for machines equipped with liquid soap pump.
The liquid soap pump can be turned off by once again pressing the button.
I: ROTATING TIME BUTTON
By pressing this button, the rotation time of the drum will change from normal to gentle.
J: EMERGENCY STOPPING
In case of an emergency, the emergency button can be pressed at any time.
7.The end of the washing cycle is indicated by the washing program indicator. Soon as the lower light on the
control panel turns off, the door can be opened by using the door handle, and remove the laundry from the
drum.

4.5. MACHINES WITH CARD PROGRAMMER

6.Check if the set temperatures on the thermostat (6) correspond to the selected card.
7.Set the switch (1) to the "0" position. Insert the (2) program card into the programmer, so that the thick blue
line is not visible.
8.Set the switch (1) to the "1" position and press the green button (3) to start the washing program. The light
(9) is on when the programmer is running, and is off during water filling and heating.
– If you want to interrupt the program, move the switch (1) to the "0" position. To skip or repeat a part of the
program, move the switch to the "0" position, turn the thumb wheel (4) to move the card forward or backwards
and return the switch (1) to the "1" position.
– The washing machine can be stopped during operation by pressing the (5) button. If you want to turn on the
machine, press the green button (3).
– The "EMERGENCY STOP" button (7) is only used in case of danger, operator health hazard or when
damage to the machine may occur.
– After pressing the "EMERGENCY STOP" button (7), all functions will stop, no light will be on, the door will
remain locked and it will not be possible to open the door.
– In order to restart the machine after correcting the cause for stopping, pull out the "EMERGENCY STOP"
button (7) and press the START button (3).
– The light (10) lights up if a failure has occurred in the door lock during operation.
9.The end of the washing cycle is indicated by an acoustic signal. After that the (program run) light will turn
off, and a green button will light up.
Press the green button (8), open the door using the door handle and remove the laundry from the drum. It
is possible to remove the card from the programmer after moving the switch (1) to the "0" position.
508 761 PUB DATE: 01/03
Fig. 4.5. A Card programmer
USER´S MANUAL 9