Setting Default Signal Out - Sony DIRECTV SAT-HD300 Operating Instructions Manual

8-10. Setting Default Signal Out

Output Channel
If you use the OUT TO TV jack, select channel 3 or 4 to send RF signal from your DIRECTV
HD Receiver to your TV. Your TV must be tuned to the selected channel to display the pic-
ture.
Loop Through
A signal from CABLE IN or ANT IN jacks is passed through to the OUT TO TV jack w hen
your HD receiver is in the standby (pow er off) mode.
To set Out to TV settings of the DIRECTV HD Receiver:
1. Press the M ENU button on the Remote Control to display the on-screen menu.
2. Scroll dow n using "
3. Select the Setup menu by pressing "
4. Scroll dow n to Out To TV using "
5. M ove the highlight to the right w ith "
6. Select your output channel to Channel 3 or Channel 4 by pressing "
7. Press the M ENU button to return to the previous menu or press the EXIT button on the
Downloaded from: https://www.usersmanualguide.com/
E " on the remote control.
Select your default signal source to Antenna or Cable by pressing "
remote control to return to TV view ing.
" .
" .
E
G " .
®
F G " .
F G " .
82