Touch Key Receptacle; Contact Switch (Optional); Anti-Hijack Button (Optional); Pinout Table - Gemini 954N User's And Installer's Manual

18.0 - ACCESSORIES

18.1 - TOUCH KEY RECEPTACLE

The receptacle with built-in LED must be installed where it can readily be seen
and accessed by the user. The LED warning light serves as both a system
status indicator and a visual deterrent.
Always check the rear clearance before drilling. If drilling a hole in the plastic
dash, check the position of the handlebars with the steering lock engaged.
Make sure the LED will not be covered by the handlebars when the vehicle is
parked. Drill size for the touch key receptacle: 13mm
Touch key

18.3 - ANTI-HIJACK BUTTON (OPTIONAL)

Connect the anti-hijack button to the White-Violet wire. The anti-hijack will
trigger when a negative signal is detected.

19.0 - PINOUT TABLE

! ATTENTION
This alarm system is intended for 12V turn indicators.
Before you do any electrical work, make
12V signal.
PAGE 19
sure the flashers are powered by a
CAUTION
Alarms are supplied without wiring harnesses. A wide range of specific pin-
to-pin wiring harnesses is available for the most common motorbikes.
The following tables refer to the generic wiring harness
Pos. Wire color
- 1 - Brown
Brown
- 2 -
White-Violet
- 3 -
Green-Brown
- 4 -
---
- 5 -
---
- 6 -
- 7 -
Yellow
- 8 -
Black
Green
- 9 -
Grey
- 10 -
White
- 11 -
White-Grey
- 12 -
Orange
- 13 -
Red
- 14 -
Orange
- 15 -
Black
- 16 -
IMMOBILIZER - wire joint
Wire color
Attach to cut end of key switch wire
White
Attach to cut end of main wiring harness.
Grey
IMMOBILIZER - grounded wire
Wire color
Connect to a permanent negative connection
White
(do not connect to vehicle chassis
Connect to the cable end which, if grounded, will kill
White/Grey
KITCA 417N17.
Wire function
Touch key earth ground
Power supply earth ground
LEARN button / Anti-hijack
Contact switch input
N/A
N/A
Ignition
LED negative output
Touch key input
Immobilizer (N.C.)
Immobilizer (Com.)
Immobilizer (N.O.)
Turn indicators (12V, 6A max.)
Positive supply
Turn indicators (12V, 6A max.)
Antenna
Connections
.
Connections
).
the engine.
PAGE 20