Technologically Advanced Sensors; How To Check Your Inner And Outer Combined Motion And Presence Detection Sensors - Assa Abloy Besam SL500 User Manual

Technologically advanced sensors

The ASSA ABLOY Entrance Systems sensors have been tested and approved by the ASSA ABLOY En-
trance Systems test laboratory for use on ASSA ABLOY Entrance Systems's automatic sliding doors.
These presence sensors further improve the already high obstruction detection obtained with the
built in self-monitored crush force limitation.
Monitored sensors have built-in monitoring for error detection.
Note! If you have a problem you cannot correct, turn off the automatic door immediately and call
your ASSA ABLOY Entrance Systems service representative for assistance.
How to check your inner and outer combined motion and presence detection
sensors
Combined sensors are used when you want both a motion sensor and a presence sensor integrated
into the same unit.
When walking towards the door opening at moderate speed, the door should start opening when
you are about 1.5 meter from the door. It shall slide open smoothly and stop in the fully open position.
Repeat the same procedure from the other side of the door opening. Move slowly through the door
(about 15 cm/s). The door shall remain open.
If your door is set up for one-way traffic, the sensor on the side not intended for use shall reopen the
closing door if an object is detected at a minimum of 20 cm from the door at floor level.
Step out of the detection field. After a short time delay the door shall slide closed smoothly.
Walk parallel to the inner door face (about 80 cm from the door face) to check that your motion is
detected during at least the complete door opening width. Repeat the same procedure on the outer
door face.
ILL-01638
12 Issue 2015-10-23 1009216-EI-4.0