Installation; Removal; Battery Maintenance; Battery Inspection And Cleaning - Snorkel SL26 Series Parts And Service Manual

SERVICE AND REPAIR
CHOCKING THE ELEVATING ASSEMBLY

INSTALLATION

1. Park the work platform on a firm, level ground
and leave the engine running.
2. Elevate the platform approximately 300 mm (12
inches).
3. Place a jackstand with a minimum rating of
2000 kg (400 lbs.) between the lower mast and
chassis, just behind the front axle.
4. Gradually lower the platform until the jackstand
is secured tightly between the lower mast and
chassis.

REMOVAL

Elevate the platform until the jackstand can be removed. Remove the jackstand and completely
lower the platform.

BATTERY MAINTENANCE

BATTERY INSPECTION AND CLEANING

Check the battery fluid level daily, especially if the work platform is being used in a warm, dry cli-
mate. If required, add distilled water only. Use of tap water will shorten battery life due to its high
mineral content. The battery and cables should be inspected regularly for signs of cracks in the
case, electrolyte leakage and corrosion of the terminals. Inspect cables for worn spots or breaks in
the insulation and for broken cable terminals. Clean the battery when it shows signs of corrosion
at the terminals or when the electrolyte has overflowed during charging. Use a suitable solution to
clean the battery, taking care not to get the solution inside the cells. Rinse thoroughly with clean wa-
ter. Clean battery and cable contact surfaces to a bright metal finish whenever a cable is removed.
Page 3 - 4
! C A U T I O N
DO NOT support or raise the front of the platform during any
maintenance operation as this may result in damage to the tension
members.
W A R N I N G
!
Before performing maintenance on a work platform while it is elevated,
ensure that the elevating assembly is properly supported.
DO NOT stand under the elevated assembly area while installing or remov-
ing the jackstand.
! W A R N I N G
Hazard of explosive gas mixture. Keep sparks, ame and smoking material
away from batteries.
Always wear safety glasses when working with batteries.
Battery uid is highly corrosive. Thoroughly rinse away any spilled uid
with clean water.
!
!
Figure 3-1: Blocking the elevating assembly
!
SL26/30SL