Daily Preventative Maintenance Schedule - Snorkel SL26 Series Parts And Service Manual

DAILY PREVENTATIVE MAINTENANCE SCHEDULE

MAINTENANCE TABLE KEY
Y = Yes/Acceptable
N = No/Not Acceptable
R = Repaired/Acceptable
COMPONENT
INSPECTION OR SERVICES
Operator's Check that the operators manual is in
Manual the manual holder and all pages are
intact and readable
Labels & Check that labels and decals are in
Decals place, intact and readable
Entire Unit Perform pre-operation inspection
Check for and repair any damage
Electrical Check cables and wiring harness condi-
system tion (No wear or physical damage)
Battery Check electrolyte level
System
Check battery cable condition
Check terminals are clean and connec-
tors are tight
Check charger condition and operation
Charge batteries
Hydraulic Check oil level
fluid
Hydraulic Check all fittings are tight and there are
system no leaks
Drive motors Check for operation and leaks
Hydraulic Check fittings are secure and there are
pump no leaks
Emergency Check emergency lowering correctly
lowering (See emergency lowering procedure)
Controller Check condition and operation
Platform Check fasteners are in place, correctly
deck and tightened and not damaged
rails
Check the structure and welds for dam-
age, deformation, corrosion and cracks
Check condition of deck (no damage,
deformation, corrosion or cracks
Check entry gate closure functions
correcly
Table 2-2: Daily preventative maintenance
Table 2: Daily preventative maintenance check-
checklist
list
SL26/30SL
INSPECTION AND MAINTENANCE
Date: ______________________________
Owner: _____________________________
Model #: ____________________________
Serial #: ____________________________
Serviced by: _________________________
COMPONENT
Y N
R
Elevating
assembly
Chassis
Lift Cylinders
Wheels
Harness
anchor point
System func-
tion inspec-
tion
Emergency
stops
Brakes
Horn
Controller
and Sensors
* NOTE: Use ISO #46 during summer
and ISO #32 during winter
PREVENTATIVE MAINTENANCE REPORT
INSPECTION OR SERVICES
Inspect for external damage, dents, loose
rivets or cracks.
Check the structure and welds for dam-
age, deformation, corrosion and cracks
Check cables for pinch or rubbing points
Check the structure and welds for dam-
age, deformation, corrosion and cracks
Check for leaks
Check for loose components
Check for damage to tyres
Check fasteners are secure
Check for damage, deformation, corrosion
and cracks
Conduct system function inspection (see
system function inspection procedure)
Check that the emergency stop button on
the basket panels operates correctly
Check that the emergency stop button
on the ground control panel operates
correctly
Check that the brakes operate correctly
Check that the horn sounds when acti-
vated
Check that the level sensor functions cor-
rectly (drive and platform raise functions
are disabled and only platform lowering
enabled) when the platform inclination ex-
ceeds the specification inclination value.
Check full drive speed range is enabled
when the platform is stowed.
Check that only reduced drive speed
range is enabled when the platform is
elevated.
Y N
R
Page 2 - 21