Snorkel SL26 Series Parts And Service Manual page 10

WARNING
All personnel shall carefully read, understand and follow all safety rules and operating instructions before operating or
E L E C T R O C U T I O N
HAZARD
THIS MACHINE IS NOT
INSULATED
USE OF THE AERIAL WORK PLATFORM: This aerial work platform is intended to lift a person or persons and their tools in-
cluding material needed for a job. The work platform is designed to be used for repair and assembly jobs ONLY at overhead work
places (ceilings, cranes, roof structures, buildings, etc.).
The use and operation of the aerial work platform as a lifting tool or a crane is prohibited!
Climbing up the railing of the platform, standing on or stepping from the platform unto buildings, steel or prefab concrete structures
etc is prohibited!
NEVER use the machine if damaged, not functioning properly, has damaged or missing decals.
NEVER attach notice boards etc. to the platform as this will increase the wind loading.
INSULATION: The aerial work platform is not insulated. It is imperative to keep a safe distance from live parts or electrical
equipment. DO NOT get closer than the minimum distance recommended by the "National Regulations".
PLATFORM CAPACITY: Exceeding the specified permissible maximum load is prohibited! Refer to platform capacity on page 24
for details.
MANUAL FORCE: NEVER exceed the manual force allowed for this machine. Refer to special limitations on page 9 for details.
LOAD DISTRIBUTION: Ensure that all loads are distributed evenly on the platform.
SURVEILLANCE: NEVER operate the machine without first surveying the work area for surface hazards such as holes, drop-offs,
bumps, curbs or debris and avoiding them.
WHEEL LOAD: OPERATE the machine only on surfaces capable of supporting wheel load.
WIND SPEED: NEVER operate the machine when the wind speed exceeds the machine's wind speed rating. Refer to the Beaufort
scale for details.
EMERGENCY STOP: In case of an emergency, push the EMERGENCY STOP switch to de-activate all powered functions.
ALARM: If the alarm sounds while the platform is elevated, STOP operation immediately and carefully lower the platform. Move the
machine to a firm, level surface.
SWING GATE: Dismantling the entry gate or other railing components is prohibited! Always make certain that the entry gate is
closed and securely locked.
It is prohibited to keep the entry gate in an open position when the platform is raised.
Extending the height of the platform by placing ladders, scaffolds or similar devices on the platform is prohibited!
SERVICING: NEVER perform service on machine while platform is elevated without blocking the elevating assembly. Refer to
"maintenance" for details.
INSPECT: the machine thoroughly for cracked welds, loose or missing hardware, hydraulic leaks, loose wire connections and
damaged cables or hoses before usage.
DECALS: VERIFY that all labels are in place and legible before using the machine.
BATTERIES: NEVER charge batteries near sparks or open flame. Charging batteries emit explosive hydrogen gas.
STORAGE: AFTER USE, secure the work platform from unauthorised use by turning the key switch off and removing the key.
HARNESS: Harness attachment points are provided on the platform and the manufacturer recommends the usage of a fall restraint
harness especially where required by national safety regulations.
Modifications to the aerial work platform are prohibited or permissible only at the approval of the manufacturer.
ENVIRONMENTAL TEMPERATURE LIMITATION: The machine is primarily for use in normal ambient temperatures and conditions
ranging between 50C to -20C
Page 2 - 2
SAFETY RULES
performing maintenance on any SNORKEL aerial work platform.
TIP OVER HAZARD COLLISION HAZARD
NEVER ELEVATE THE
PLATFORM OR DRIVE
THE MACHINE WHILE
ELEVATED UNLESS THE
MACHINE IS ON A FIRM
LEVEL SURFACE
NEVER POSITION THE NEVER CLIMB, STAND
PLATFORM WITHOUT OR SIT ON PLATFORM
FIRST CHECKING GUARDRAILS OR MID
FOR OVERHEAD
OBSTRUCTIONS OR
OTHER HAZARDS
FALL HAZARD TRAPPING/CRUSHING
BEWARE OF CRUSHING
HAZARD WHEN HOLDING
HANDRAILS WHILE THE
PLATFORM IS MOVING
RAIL
IN CLOSE PROXIMITY TO
HAZARD
OTHER OBJECTS
SL26/30SL