Automatic Operation - Brief Instructions - BÖWE P12 Instruction Manual

6. Operation

6.2. Automatic Operation - Brief Instructions

Open valves for water, steam, condensate, compressed air.
Set up the power supply
Before starting, make sure that all doors and covers are closed.
Main switch "ON"
Display:
Machine type, such as:
Then the deodorizing program "P43" is displayed.
Press the "Start " button.
After the signal sounds, press the "Stop" button.
Loading:
Open the loading door, load the cage according to the filling capacity,
close the loading door.
Erase the displayed, previous program
P43 by pressing "C".
Select a program according to the overview.
Input the required program
(program and number) e.g. 2
Start:
Press "Start". May be the sign E114 appears. Erase by pressing "C".
The program executes automatically.
During automatic and manual operation, the loading door is locked
from the start of the cycle until the end (signal).
If there is a failure or if the door limit switch is not adjusted correctly,
there will be an alarm indication.
A signal that sounds in intervals announces that the program has ended.
Stop: Press the "Stop" button. *
Open the loading door and unload the garments.
Close the loading door.
If you repeat the same program, you only need to load the garments,
close the loading door and press the "Start" button.
If you do not restart the machine, the loading door locks after 1 minute.
You can unlock the door with the arrow key for up to 10 minutes.
After 11 minutes, start the deodorizing program "P43".
Shut the machine down immediately if there are dangers of any kind,
such as if unbalances occur during the spinning cycle. Turn off the
main switch.
Caution
* When pressure in the machine has built up (visible as a block diagram in the display) the signal
E106 appears. When the pressure has dissipated, the loading door unlocks and can be opened.
36
"BOEWE"
„Textile Cleaning"
"P12 "
6.
6.2
START
STOP
C
2
PROG
START
STOP
STOP
P12 /P15 /P18