6. Operation
6.1.4. Filling Slimsorba Carbon Container (Optional Equipment)
-
Loosen the upper tube of the carbon container (disassemble hose connections, and aeration
line).
-
Loosen the quick release fastener on the cover and lift off the cover.
-
Remove fine filter sieve and clamping ring.
-
Fill in 13 kg/28.7 lb of activated carbon (cylindrical pellets with approx. 4 mm/0.16 inch diameter,
type SUPERSORBON K40). The heating coil must be covered.
-
Replace the fine filter sieve and clamping ring.
Replace the cover and close the quick release fastener.
-
Secure the upper tube of the carbon container again (assemble hose connections, and aeration
-
line).
6.1.5. Filling the Water Separator
Pump solvent from tank I to the still for about 15 seconds:
5
+
PROG
PROG
+
HOLD
The distillation heating starts automatically. Distillation fills the water separator.
6.1.6. Filling the Economy Filter
Start filter maintenance program P46 (filter 1) or P47 (filter 2), starting with step n09
4
+
+
PROG
When using filter powder (optionally):
- First place the precoating bag with the prescribed amount of filter powder (1.2 kg/2.6 lb) into
the cage, then start P46 (filter 1) or P47 (filter 2), as described above..
Attention:
Do not use filter powder on machines with an emission-free still
rakeout system.
9
+
+
START
C
C
+
+
6
+
+
HOLD
28
15 seconds
STOP
„fill drum" +
6.
START
P12 /P15 /P18