Base Unit Placement; Installation Example Of The Base Unit - Epson ELPBU01 User Manual

Base Unit Placement

When you are using the base unit as a receiver for the wireless transmitter,
you need to set up the base unit.
You can install the base unit on a wall or ceiling, or place it on a table to
connect the external display equipment such as a projector or a large display.
Use the mount supplied to install the base unit on a wall or ceiling.
Install a base unit around the external display equipment within the wireless
LAN range.
Warning
• A special method of installation is required when installing the base unit to the
higher location such as a wall or ceiling. If you do not install the base unit
correctly, it could fall and cause an accident or injury.
• If you use adhesives on the mount fixing points to prevent the screws from
loosening, or if you use things such as lubricants or oils on the base unit, the case
may crack causing it to fall from its mount. This could cause an accident or
injury to anyone under the mount. When installing or adjusting the ceiling
mount, do not use adhesives to prevent the screws from loosening and do not
use oils or lubricants and so on.
• Do not install the base unit in a location subject to high levels of dust or
humidity, or in a location subject to smoke or steam. Otherwise, it could cause a
fire or electric shock to occur. The base unit's case could also deteriorate and be
damaged causing the base unit to fall from the mount.
Examples of environments that could cause the base unit to fall due to case
deterioration
• Locations subject to excessive smoke or airborne oil particles, such as factories
or kitchens
• Locations containing volatile solvents or chemicals, such as factories or
laboratories
• Locations where the base unit could be subjected to detergents or chemicals,
such as factories or kitchens
• Locations in which aroma oils are often used, such as relaxation rooms
• Near devices that produce excessive smoke, airborne oil particles, or foam at
events
• Do not use or store the base unit in locations where it will be subject to dust or
dirt. Otherwise, resulting in a malfunction or fire.
Caution
• When mounting on the wall, install the base unit so that the interface faces
downward. If it is installed facing upward, dust could collect on the ports and
cause a short circuit or fire.
• When wiring, make sure that you do not place the cable on the base unit.
Shielding the internal antenna with a cable could affect wireless performance.
• Do not overload cables and connectors. It could cause damage.
• Do not install the base unit in the following places where it may get hot. It could
be affected by heat.
• Near the exhaust vents of the projector
• Back of large display
g g Related Links
• "Installation Example of the Base Unit"
• "Installing the Base Unit on a Wall"

Installation Example of the Base Unit

You can set up or install your base unit in the following ways:
Mounted on a wall
Mounted on a ceiling
p.22
p.23
22