Pairing the Wireless Transmitter
The network information is started to be written to the wireless
transmitter. It may take some time until the pairing is finished.
f
Remove the wireless transmitter from the base unit when the ending
message is displayed on the screen.
Repeat step 5 and 6 to perform paring any other wireless transmitters as
necessary.
Pairing on a Computer
You can pair the wireless transmitter with the receiver (base unit or supported
projector) on a computer using the Epson Wireless Transmitter Settings
software.
You can download and install Epson Wireless Transmitter Settings from the
following Web site.
epson.sn
See the Epson Wireless Transmitter Settings Operation Guide for instructions.
Pairing Using a Projector
When using Epson Wireless Presentation System (ELPWP10), you can pair
the wireless transmitter with a supported projector.
Attention
Depending on the projector model, you need to update the firmware.
a
Turn on the projector.
b
Remove the USB conversion adapter for the wireless transmitter and
connect the transmitter to the projector's USB-A port.
The network information is started to be written to the wireless
transmitter. It may take some time until the pairing is finished.
c
Remove the wireless transmitter from the projector when the ending
message is displayed on the screen.
Repeat step 2 and 3 to perform paring any other wireless transmitters as
necessary.
Select Yes to set Connection Guide Display to On if necessary.
You need to install the wireless LAN module (ELPAP11) to the
projector before starting wireless projection.
a
21