Table of Contents
Advertisement
Pairing the Wireless Transmitter
e
Remove the USB conversion adapter on the wireless transmitter and
connect the transmitter to the base unit's USB-A port.
The pairing process starts. The wireless transmitter indicator flashes
alternately blue and orange during pairing. When pairing is complete,
the wireless transmitter indicator is lit blue and a completion message is
displayed on the screen if the base unit is connected to an external display
device. The pairing process may take some time to complete.
f
Remove the wireless transmitter from the base unit.
Repeat steps 5 and 6 to perform pairing with any other wireless
transmitters as necessary.
Pairing on a Computer
You can pair the wireless transmitter with the receiver (base unit or supported
projector) on a computer using the Epson Wireless Transmitter Settings
software.
You can download and install Epson Wireless Transmitter Settings from the
following Web site.
epson.sn
See the Epson Wireless Transmitter Settings Operation Guide for instructions.
Pairing Using a Projector
When using the Epson Wireless Presentation System (ELPWP10), you can pair
the wireless transmitter with a supported projector.
Attention
Depending on the projector model, you may need to update the firmware.
a
Turn on the projector.
b
Remove the USB conversion adapter for the wireless transmitter and
connect the transmitter to the projector's USB-A port.
Network information is automatically written to the wireless transmitter.
The pairing process may take some time to complete.
c
Remove the wireless transmitter from the projector when a completion
message is displayed on the screen.
Repeat steps 2 and 3 to perform pairing with any other wireless
transmitters as necessary.
Select Yes to set Connection Guide Display to On if necessary.
You need to install the wireless LAN module (ELPAP11) on the projector
before starting wireless projection.
22
Advertisement
Table of Contents
