Nortel CallPilot 703t Installation And Configuration Manual page 285

October 2003
To configure the BIOS
Note: Only options that need to be changed from their defaults are described
below. As you perform this procedure, you should still validate that all BIOS
settings conform to the values listed in "BIOS settings," on page 277.
1 During the server startup and while the startup diagnostics still appear on
the screen, press F2 to display the Main menu screen.
2 Press BIOS Default (F9) to load the default BIOS settings.
Result: You are prompted to confirm the settings.
3 Choose Yes, and then press Enter.
Result: The Main menu reappears.
4 Use the right and left arrow keys to choose the Advanced screen.
Result: A list of configuration sections appears.
5 Configure the sections as follows:
Boot-up Diag Screen: Enabled
Num Lock: ON
Sleep Button: Disabled
6 Use the right and left arrow keys to choose the Server screen.
Result: A list of configuration sections appears.
7 Configure the sections as follows:
Assert NMI on PERR: Disabled
Assert NMI on SERR: Disabled
8 Use the right and left arrow keys to choose the Boot screen.
Result: A list of configuration sections appears.
9 Ensure the boot device order is defined as follows:
first: floppy drive
second: hard drive
Part 5: 703t Server Maintenance and Diagnostics
Working with the CallPilot server BIOS
285