Mitsubishi Electric RFID ECL2-V680D1 User Manual page 57

4. SETUP AND PROCEDURES PRIOR TO OPERATION
No. Name
Indicaters LED
1)
4 - 8
Table 4.2 Names of Parts
Indicates the power supply status.
PW On: Power on
Off: Power off
Indicates normal operation.
On : Operating normally in RUN mode.
Flashing : Operating normally in TEST mode.
RUN
Off : Fatal error.
Indicates the CC-Link data communication status.
L RUN On: When communication is normal
Off: When communication is disconnected (timeover error)
Indicates the CC-Link data send status.
SD On: Sending data
Off: Not sending data
Indicates the CC-Link data reception status.
RD On: Receiving data
Off: Not receiving data
Indicates a CC-Link error.
On: Communication data error (CRC error) or station number / transmission
speed switch setting error
Flashing (Regular interval):
When the station number or transmission speed switch setting was changed
L ERR.
while the system was powered.
Flashing (Irregular interval):
Forgot to attach a terminating resister. When the module or CC-Link dedicated
cable is impacted by noise.
Off: Operating normally
Indicates the operating status.
BSY. On: Executing ID command or executing TEST mode
Off: Standby
Indicates the communication complete status.
NOM. On: ID command normal end or TEST mode normal end
Off: Standby or abnormal end
Indicates whether or not an error exists.
On: Error
ERR.
Flashing: Error occurred during the TEST mode communication test
Off: Normal
Description
Hardware error
WDT error
4 - 8