Mitsubishi Electric RFID ECL2-V680D1 User Manual page 3

 When installing the RFID interface module and amplifier/antenna cables, do not bundle the
cables with or install the cables close to the main circuit, power lines, or the like. Be sure to
separate the cables and lines by about 100mm or more. Failure to do so will cause noise,
resulting in malfunction.
 When storing the product, be sure to observe the defined storage ambient temperature and
humidity. Failure to do so will lead to module malfunction and failure.
 Look the control panel so that only those who are trained and have acquired enough knowledge
of electric facilities can open control panel.
 Install the emergency stop switch outside the control panel so that workers can operate it easily.
[INSTALLATION PRECAUTIONS]
 Use the module in an environment that reflects the general specifications stated in the manual.
Using the module in an environment out of the general specification range results in the risk of
electric shock, fire, malfunction, and product damage or deterioration.
 Fully secure the module using a DIN rail or installation screws, and fully tighten the screws within
the specified torque range. If a screw is too loose, a dropped module, short circuit, or malfunction
may result. If a screw is too tight, screw and/or module damage may occur, resulting in a
dropped module, short circuit, or malfunction.
 Do not directly touch a powered section of the module. Doing so results in the risk of module
malfunction and failure.
[WIRING PRECAUTIONS]
 Be sure to shut off all phases of the external power supply used by the system before performing
work such as wiring. Failure to do so results in the risk of product damage, and malfunction.
 Be sure to ground the FG terminal using programmable controller dedicated class D (type 3)
grounding or greater. Failure to do so results in the risk of electric shock and malfunction.
 Be sure to tighten any open terminal screws within the specified torque range. Failure to do so
causes a short circuit.
 Use the appropriate crimp terminals, and tighten the terminals to the specified torque. If a crimp
terminal with an open end is used, the terminal screw will fall off if loose, causing failure.
A - 2
CAUTION
CAUTION
WARNING
CAUTION
A - 2