2: Basic Activation - FIBARO FGFS-101 Operating Manual

#2: Basic activation

1. Turn the cover counter-clockwise and open it
2. Remove the battery blocker
3. Flood Sensor will confirm being powered with a short beep
4. Add the device (see "Adding/removing the device" on page 6)
5. Close the cover and turn it clockwise
6. Place the sensor onto a surface prone to flooding. Three elec-
trodes underneath the device should evenly touch the surface.
5
i
NOTE
After completing
installation it is rec-
ommended to test
sensor's operation
by placing the entire
sensor or its probes'
extension wire onto
water surface.
i
NOTE
When changing the
Sensor's location, it's
recommended to
wake up the device
and reconfigure the
Z-Wave network by
triple clicking the TMP
button.
BASIC ACTIVATIOn