Standalone Media Converter In Sml Mode; Figure 14: Copper Connection Down With Sml Off; Figure 15: Sml In Normal Condition; Figure 16: Sml With Fiber Connection Down - Allied Telesis DMC1000/100 Series Installation Manual

Link LED Off
Standalone
Media Converter
in SML Mode
End Node
Link LED Off
Figure 14 shows media converter and end node LINK/ACT LED behavior
with SML off with a copper connection down.
End Node
Copper Cable
Link Down
Figure 14. Copper Connection Down with SML Off
Following are example scenarios with one SML enabled media converter
connected between two end nodes.
Figure 15 shows media converter and end node LINK/ACT LED behavior
with SML enabled under normal conditions.
End Node
Copper Cable
Link Up
Link LED On
Figure 16 shows media converter and end node LINK/ACT LED behavior
with SML enabled with a fiber connection down.
End Node
Copper Cable
Link Down
Link LED Off
Figure 16. SML with Fiber Connection Down
Figure 17 shows media converter and end node LINK/ACT LED behavior
with SML enabled with a copper connection down.
Copper Cable
Copper
LINK/ACT
Link Down
LED
Figure 17. SML with Copper Connection Down
DMC1000/100 Series Media Converters Installation Guide
SML Off
AT-DMC1000
Copper Fiber
LINK/ACT LINK/ACT
LED LED
Off On
AT-DMC1000
Copper
LINK/ACT LINK/ACT
LED On LED On
Figure 15. SML in Normal Condition
AT-DMC1000
Copper Fiber
LINK/ACT LINK/ACT
LED LED
Blinking
AT-DMC1000
Fiber
LINK/ACT
Link Up/Down
LED
Off Blinking
*
This behavior may cause problems with some switches.
on page 24
See Figure 10
Fiber Cable
Link Up Link LED On
Fiber Cable
Fiber
Link Up
Fiber Cable
Link Down
Off
End Node
Fiber Cable
*
Link LED Blinking
for more information.
End Node
End Node
Link LED On
End Node
Link LED Off
29