Replacing Front Wiper Blades - MG ZS Manual

MAINTENANCE

Replacing Front Wiper Blades

1 With the bonnet closed and the ignition switch in
the OFF position, within 20 seconds of switching the
ignition OFF press the wiper switch down and release,
the wipers will enter the 'service position' and stop on
the windscreen.
2 Lift the wiper arm away from the windscreen.
276
3 Press the retaining clips at both sides (as shown in
the figure), whilst pulling the wiper blade outward,
to remove the wiper blade from the wiper arm and
discard.
4 Position the fitting of the new wiper blade into the slot
of the wiper arm.
5 Push the wiper blade towards the wiper arm until the
it is located embedded with a click been heard.
6 Place the wiper assembly back on the windscreen.
7 Press down the wiper stalk switch again and release,
or turn on the ignition switch, the wiper will exit the
service mode and automatically return to its original
position.