Table of Contents
Advertisement
EMERGENCY INFORMATION
Rear Direction Indicator Bulb Renewal
1 Open the tailgate.
2 Disconnect the battery negative terminal.
3 Using a suitable pry bar or lever, carefully release and
remove the securing screw cover trim.
4 Using a suitable 10 mm spanner/socket wrench,
remove the 2 screws securing the lamp to the body.
5 Release the lamp assembly and remove away from the
body.
6 Rotate the bulb holder (2) in an anti-clockwise
direction.
7 Remove bulb holder and remove bulb.
8 Fit bulb to bulb holder.
9 Insert bulb holder in lamp assembly, rotate clockwise
until fully secure.
10 Ensure lamp seal is correctly located.
11 Position lamp to body, start both screw fixings, tighten
to 3-5 Nm.
248
12 Refit screw cover trim.
13 Reconnect battery negative terminal.
14 Test lamp operation.
15 Close tailgate.
Advertisement
Table of Contents
