MG ZS Manual page 250

EMERGENCY INFORMATION
1 Before raising the car, use the special tool supplied
with the vehicle to remove each wheel bolt cap. Use
the wheel bolt spanner to slacken each bolt half a turn
anti-clockwise.
2 Turn the handle in a clockwise direction until the tyre
is clear of the ground.
3 Remove the wheel bolts and place them in the tool tray
to prevent them from being lost. Make sure the vehicle
is steady and there is no risk of slip or movement
before removing wheel bolts.
4 Remove the road wheel.
Note: Avoid placing wheels face down on the
ground - the surface may be scratched.
5 Fit the spare wheel and tighten the wheel bolts with
wheel bolt spanner until the wheel is seated firmly
against the hub.
6 Lower the car and remove the jack, then FULLY tighten
the wheel bolts in a diagonal sequence.
7 Finally, return the tools to the toolbox, put the toolbox
into the well of the boot floor, tighten the spare wheel
234
retaining nuts, and put the replaced wheel above the
toolbox in the well in the load space floor (face down).
Lower the boot floor, and put the boot storage box on
the boot floor.
Note: DO NOT stand on the handle of the wheel bolt
spanner or use extension tube on the handle of the
spanner.
Note: When replacing the wheel, please fully tighten
the bolts in the diagonal sequence twice.
Note: Consult your MG Authorised Repairer or tyre
specialist for a replacement tyre, as soon as possible.
Spacesaver Spare Wheel
Only one spacesaver spare wheel can be used
at any one time, otherwise the operational
performance and brake performance may be
reduced, thereby leading to accident or injury
to yourself and others.