Valor G4 Series Installation And Operating Instructions Manual page 7

Removing the fan or control module
If you need to replace the fan or the control module
from their enclosure, proceed as follows.
1.
Removing the fan. The fan is fixed to its enclosure
with pegs.
a) Grab the fan and pull it out carefully as it is still
connected to the control module.
b) To disconnect the fan, remove the two "L"
shaped connectors on top of the fan motor and
the ground wire.
Note: Grab the whole connector when
disconnecting—DO NOT pull on the wires!
c) Disconnect the green ground wire from the fan
itself using a 9 mm wrench.
NOTE: If the fan needs to be replaced, make
sure the replacement is fitted with foam pads
and rubber grommets as this allows the fan
to be tight within the enclosure to avoid any
vibration when functioning.
Foam pads (4)
Rubber grommets (4)
2.
Removing the fan control module. The module is
held in place by a piece of Velcro.
Disconnect the power, the fan, and the receiver
connectors to release the module.
Note: Grab the whole connector when
disconnecting—DO NOT pull on the wires!
Fan module to fan connectors
Fan module to receiver connector
3.
Reconnect and reinstall the module and the fan
after servicing if disconnected.
4.
Refit the fan enclosure to the back of the appliance
(9 screws).
5.
Rethread the wire from the fan control module to
the receiver and plug it to the receiver as indicated
on page 3 of this manual.
6.
Plug the fan in its electrical outlet.
7.
Test the fan function as indicated on page 3 of this
manual to ensure all the connections are working.
8.
Refit the left side access panel to the appliance (5
screws).
9.
Refit the appliance in the cavity.
10.
Refit the vent plate on top of the appliance and fix it
in place (2 screws).
11.
Refit the front and trim which were previously
removed to access the fan.
7